Contents: Dismantling ⇩ Assembly ⇩
Dismantling
1. Disconnect the negative battery terminal.
2. Raise the rear of the vehicle on one side.
CAUTION: Do not work under a vehicle supported solely by a jack or lift. Always support the vehicle with safety stands.
3. Remove the right rear wheel.
4. Release the pump from the rubber support.
5. Disconnect the connector block from the fuel pump.
6. Loosen the fasteners and disconnect the fuel lines from the pump.
CAUTION: Before disconnecting or removing system components, make sure that the adjacent surfaces of the joints are free of dirt. Install plugs in the openings of the fittings and pipes to prevent dirt from entering the system.
7. Separate the fuel pump from the vehicle and remove the rubber mount.
Assembly
1. Clean the fuel hose connectors.
2. Install the rubber support on the pump.
3. Align the fuel lines with the pump and secure them with clamps.
4. Connect the electrical connector block to the fuel pump.
5. Install the fuel pump assembly onto the support bracket.
6. Replace the wheel and tighten the nuts to a torque of 140 Nm.
The original article can be found here: LRman.ru
7. Lower the vehicle.
8. Connect the negative battery terminal.
Comments on this article