Air intake air filter (Range Rover 3)

Dismantling

1. Remove 3 screws and remove the air intake box cover.

2. Lift the cover and remove the air filter.

Assembly

1. Clean the air intake box from dirt.

2. Install a new air filter.

3. Install the cover and secure it with screws.

The publication was copied from a web resource (www.LRman.ru)

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article review: Platon Fedorov

Heater Control Units (ECU)
Air pollution sensor
Climate control system stepper motor
Control panel ventilation grille — face level
Control Panel Center Fans

Current article

Air intake air filter

Air intake box
Heating, ventilation and air conditioning control unit
Air distribution control motor
Electric motor of the rear passenger compartment ventilation grille
Electric motor for switching air supply modes
Right side air supply switching motor
Fan assembly with electric motor
Fan Motor Resistor Block (LHD)

Comments on this article

No comments yet

Range Rover 3