Dismantling
1. Disconnect "negative" battery terminal.
2. Remove the glove box.
CAR INTERIOR PARTS, REPAIR WORKS, Glove box.
3. Remember the installation position and disconnect 8 pads from the fuse box.
4. Remove the 4 Torx screws securing the fuse box and move it aside.
5. Remove the screw securing the floor duct to the bracket. Remove the air duct.
6. Disconnect the connector block from the resistor block.
7. Release the resistor retainer to the heater block and remove the resistor.
Assembly
1. Position the resistor on the heater block, align with the mounting tabs and secure with the retainer.
2. Connect the block to the resistor connector.
3. Position and secure the lower air duct of the heater.
4. Install the fuse box and fasten it with screws.
5. Attach blocks to sockets of the block of safety locks.
6. Install the glove box.
CAR INTERIOR PARTS, REPAIR WORKS, Glove box.
7. Attach "negative" battery terminal.
Comments on this article