Contents: Brake fluid reservoir ⇩ Clutch fluid reservoir ⇩ Power Steering Fluid ⇩ Windshield washer reservoir ⇩
Brake fluid reservoir
1. Visually check the fluid level on the transparent wall of the tank without removing the lid.
2. If the level is below the 'MAX' mark, clean the area around the filler cap of the tank and remove the cap.
3. Fill the reservoir to the 'MAX' mark with the recommended brake fluid.
For more information, please refer to the chapter: Specifications (206-00 Brake System - General Information, Specifications).
4. Replace the filler cap of the tank.
Clutch fluid reservoir
1. Clean the area around the clutch fluid reservoir cap and remove the cap.
2. Check the fluid level in the clutch hydraulic reservoir.
3. Clean the area around the filler cap of the tank, remove the cap.
The article was taken from this resource www.lrman.ru
4. If necessary, add the recommended fluid up to the 'MAX' mark on the reservoir.
For more information, please refer to the chapter: Specifications (206-00 Brake System - General Information, Specifications).
5. Replace the filler cap of the tank.
Power Steering Fluid
CAUTION: To avoid overfilling, check/top up the working fluid with the engine off and the system cold. Make sure the steering wheel is in the straight-ahead position, do not turn the steering wheel until the fluid level has been checked.
1. Make sure the fluid level is halfway between the 'MAX' and 'MIN' marks on the reservoir; add liquid if necessary.
2. Clean the area around the filler cap of the tank, remove the cap.
3. If necessary, add the recommended fluid to the middle mark on the reservoir.
For more information, please refer to the chapter: Specifications (206-00 Brake System - General Information, Specifications).
CAUTION: Do not add fluid above the "MAX" mark.
4. Replace the filler cap of the tank.
Windshield washer reservoir
1. Remove the windshield washer reservoir filler cap.
2. Add a mixture of the recommended washer fluid and water to the reservoir until it reaches the bottom of the washer reservoir filler neck.
3. Replace the filler cap of the tank.
Comments on this article