Electronic voice command recognition unit (Range Rover 3)

If the voice recognition electronic unit needs to be replaced, connect the diagnostic tool /T4 and perform the recommended steps before disconnecting the battery.

Removal

1. Remove the hatch located in the trunk on the left side.



2. Unscrew the 2 nuts securing the electronic voice command recognition unit and release the electronic unit.

3. Disconnect the connector and remove the voice recognition electronic unit.

Installation

1. Install the voice recognition electronic unit and connect the connector.

2. Install the voice recognition electronic unit and tighten the nut to 6 N·m.

3. Install the hatch back into place.

(Original article on the web portal: «www.lrman.ru»)