Draining and filling the working fluid (Range Rover 3)

Drain

1. Place the vehicle on a lift.

CAUTION: Use caution when draining hydraulic fluid, which may be very hot.

2. Apply the parking brake and place chocks under the front and rear wheels.

3. Place a container to collect the working fluid under the automatic transmission.

NOTE: Drain the transmission fluid when the transmission is at operating temperature.

4. Wipe the area around the drain plug.



5. Unscrew the drain plug and remove the sealing ring.

6. Allow the working fluid to drain.

7. Clean the drain plug, install a new sealing ring on it and tighten the plug to a torque of 25 N·m.

Filling

1. Clean the area around the filler/inspection plug.



The original text can be found at (www.lrman.ru)



2. Unscrew the filler/inspection plug and remove the sealing ring.

3. Fill with 3.5 to 4 liters of the recommended working fluid through the filler/inspection hole.

4. Install a new filler/check plug and tighten it to 35 N·m.

5. Check the working fluid level and top up to the lower edge of the filler hole.

MAINTENANCE, SERVICE OPERATIONS, Automatic transmission fluid - V8 engine.