Contents: Dismantling ⇩ Assembly ⇩
Before disconnecting the battery, make sure that all requirements and conditions contained in the section on disconnecting the battery are met.
GENERAL INFORMATION, Precautions when working with electrical equipment.
Dismantling
1. Disconnect the negative terminal from the battery.
2. Remove the air duct.
HEATING AND VENTILATION, REPAIR WORKS, Air intake box.
3. Disconnect the connector from the lock switch connector.
4. Remove the screw securing the locking switch connector retainer and release the wires from the gearbox.
5. Remove the gearbox crankcase ventilation hose.
The source of the article is located on the website LRMAN.RU
6. Raise the car on a lift.
7. Release the switch wires from the clips and place them aside.
8. Loosen the nut securing the selector lever to the lock switch and release the selector lever.
9. Remove the two screws securing the lock switch shield and remove the shield.
10. Remove the two screws securing the lock switch to the gearbox and remove the switch.
Assembly
1. Clean the lock switch and the mating surface of the transmission.
2. Install the switch, tighten the mounting screws and tighten them to a torque of 10 Nm.
3. Install and secure the lock switch wires and connect the connector block.
4. Install the switch wire retainer, tighten the screw and tighten it to 10 Nm.
5. Install the lock switch shield, tighten the mounting screws and tighten them to a torque of 10 Nm.
6. Connect the selector lever to the lock switch, tighten the nut and tighten it to a torque of 10 N·m.
7. Lower the vehicle.
8. Connect the ventilation hose to the gearbox.
9. Reinstall the air duct.
HEATING AND VENTILATION, REPAIR WORKS, Air intake box.
10. Connect the negative terminal to the battery.
Comments on this article