Intermediate shaft speed sensor current collector (Range Rover 3)

This operation also relates to the topic: slip ring - speed sensor - input shaft.

Dismantling

1. Remove the transmission pan.

AUTOMATIC TRANSMISSION - ZF 5HP24, REPAIR WORK, Gasket - automatic transmission oil pan.

2. Remove the Torx screw securing the speed sensor clamp and release the sensor from the valve assembly.

3. Disconnect the connector block from the speed sensor.

Assembly

1. Wipe the intermediate shaft speed sensor and the sensor mounting locations.

2. Connect the connector to the intermediate shaft speed sensor connector.

3. Install the sensor into the valve block, install the clamp and tighten the Torx screw to 10 Nm.

4. Replace the tray.

AUTOMATIC TRANSMISSION - ZF 5HP24, REPAIR WORK, Gasket - automatic transmission oil pan.

The full version is available on the website [lrman.ru]