Front stabilizer bar (Defender 2007+)

Removal

1. Mark the position of the rubber bushings on the anti-roll bar for assembly.

2. Unscrew the four nuts and remove the bolts and washers securing both stabilizer bar bushing clamps to the chassis support brackets.

3. Loosen the nuts and remove the bolts, washers and rubber bushings securing the anti-roll bar to both struts.

4. Remove the stabilizer.

Installation

1. Install the bushings onto the stabilizer. Make sure that the hinges are facing the bridge on the right bushing and away from the bridge on the left bushing.

2. Secure the stabilizer with two clamps. For proper installation, the inclined sides of the stabilizer must be facing down. Loosely install the bolts, washers and self-locking nuts ("nyloc").

3. Install the bolt, washers and rubber bushings. Using new nuts, connect the stabilizer to the struts and tighten to 68 Nm.

4. Tighten the clamp fastening nuts to 30 Nm.