Selector shaft locks — removal and installation (Defender 2007+)

Special tool(s)

	Hammer with movable striker 100-012
	Puller, stopper 308-657
	Impact Puller Adapter 100-012-05

General equipment

• Hammer
• Soft punch

Removal

1. Remove the gearbox.

For more information, refer to the chapter: Gearbox (308-03 Manual transmission/gearbox in block with driving axle, Removal).

2.

CAUTION: Make sure the surface surrounding the element is clean.

Assemble the special tool.



3.

CAUTION: Make sure the surface surrounding the element is clean.

Using the special tools, remove the shift fork rod retainer.

Installation

1.

NOTE: If the transmission jams while in gear, carefully move the selector mechanism using a suitable flat-blade screwdriver.

Make sure all shift fork rods are aligned as shown and the shifter clutch can move freely.



2.

CAUTION: Make sure the surface surrounding the element is clean.

NOTE: If necessary, the new shift fork rod retainer must be installed flush with the transmission housing.

Using a suitable hammer and soft drift, install the shift fork rod retainer.



3. Install the gearbox.

For more information, refer to the chapter: Gearbox (308-03 Manual transmission/gearbox in block with driving axle, Installation).