Airbag deployment (side impact) outside the vehicle (Range Rover 3)

This instruction manual is intended to assist authorized service personnel in the safe disposal of air bag modules.

Airbag deployment

WARNING: Before carrying out work on passive safety systems, it is necessary to carefully read the relevant technical documentation.

1. Follow all safety rules when working with passive safety systems.

GENERAL INFORMATION, Safety precautions when working with the airbag system (SRS).

2. Remove the airbag from the vehicle.

RESTRAINT SYSTEMS FOR DRIVER AND PASSENGERS, REPAIR WORK, Airbag module (side impact protection) - front door.

3. Check the condition of the LRT-86-003 device and the cables supplied with it.

4. Clamp the LRT-86-007/02 bracket in a vice. The vice should clamp the bracket above the lower flange to prevent the bracket from moving upward under the influence of detonation. Tighten the vice.

5. Install two LRT-86-007/05 brackets on the LRT-86-007/02 bracket and secure them with bolts.

6. Install the airbag onto the LRT-86-007/05 brackets and secure it.

7. Connect the LRT-86-003/08 cable of the device to the airbag.

8. Attach the LRT-86-003 tool to the end of the LRT-86-003/08 cable.

9. Connect the LRT-86-003 device to the battery.

CAUTION: Make sure all people are at least 15 m away from the air bag module.

10. To activate the airbag, press the power button on the device body.

11. Disconnect the device from the battery.

WARNING: When triggered, parts of the airbag heat up to a high temperature and can cause burns. Wait 30 minutes after it is triggered before touching the airbag module.

12. Disconnect the device cable from the airbag.

13. Remove the airbag module from the bracket and place it in a sealed bag for disposal.

14. Wipe the bracket with a damp cloth and remove it from the vice.

15. Dispose of the used airbag module in a designated waste incineration area.