Seat belt pretensioner activation
CAUTION: Do not perform any work on the SRS system until you have read the relevant sections of this Manual.
1. Follow all safety rules when working with the airbag system.
GENERAL INFORMATION, Forced deployment of the SRS component.
2. Remove the front passenger airbag from the vehicle.
PASSIVE SAFETY SYSTEMS, REPAIR WORK, Front passenger airbag - for vehicles up to model year 2004.
3. Check the condition of the LRT-86-003 device and the cables supplied with it.
4. Clamp the LRT-86-007/02 bracket in a vice. The jaws of the vice should clamp the bracket above the lower flange to prevent the bracket from moving upward under the influence of detonation. Tighten the vice.
5. Install two LRT-86-007/05 brackets on the LRT-86-007/02 bracket and secure them with bolts.
6. Install the airbag onto the LRT-86-007/05 brackets and secure it.
7. Connect the LRT-86-003/08 cable of the device to the airbag.
8. Attach the LRT-86-003 tool to the end of the LRT-86-003/08 cable.
9. Connect the LRT-86-003 device to the battery.
CAUTION: Make sure all people are at least 15 m away from the air bag module.
10. To activate the airbag, press the power button on the device body.
11. Disconnect the device from the battery.
CAUTION: When deployed, parts of the air bag become very hot and may cause burns. Wait 30 minutes after deployment before touching the air bag module.
12. Disconnect the device cable from the airbag.
13. Remove the airbag module from the bracket and place it in a sealed bag for disposal.
14. Wipe the bracket with a damp cloth and remove it from the vice.
The original article is located on the website: LRman.ru
15. Dispose of the used airbag module in a designated waste incineration area.
NOTE: Do not transport parts of deployed passive restraint systems in the passenger compartment of the vehicle.
16. Reuse of any parts of passive safety systems is prohibited.
Comments on this article