Contents: Dismantling ⇩ Assembly ⇩
Before disconnecting the battery, make sure that all requirements and conditions contained in the section on disconnecting the battery are met.
GENERAL INFORMATION, Precautions when working with electrical equipment.
WARNING: Before carrying out work on passive safety systems, it is necessary to carefully read the relevant technical documentation.
WARNING: Always remove both battery terminals before operating Passive Safety systems (SRS). First disconnect the "negative" terminal. Never mix up the wires when connecting to the battery pack.
Dismantling
1. Follow all safety rules when working with passive safety systems.
GENERAL INFORMATION, Safety precautions when working with the airbag system (SRS).
[Original article on the web portal: LRMAN.RU]
2. Remove the headliner.
CAR INTERIOR PARTS, REPAIR WORK, Ceiling.
3. Disconnect the connector from the airbag module.
4. Remove the 4 Torx screws securing the airbag module and remove the airbag.
CAUTION: Store the air bag model with the deployable side facing up. If the air bag is stored with the deployable side facing down, if it accidentally deploys, it will be thrown upward with sufficient force to cause serious injury.
WARNING: Store airbags or pretensioners in a specially designated place. If there is no such place, then store these elements in the trunk or luggage compartment of the car, informing the technician about this.
Assembly
NOTE: If a component of the passive restraint system needs to be replaced, the bar code of the new component must be recorded.
1. Carefully install the airbag unit and tighten the screws evenly to a torque of 10 N·m.
2. Connect the airbag cable connector.
3. Install the headliner.
CAR INTERIOR PARTS, REPAIR WORK, Ceiling.
4. Connect the battery terminals, the positive terminal first.
Comments on this article