Front Door Airbag Module (Range Rover 3)

Contents: Dismantling ⇩ Assembly ⇩

Before disconnecting the battery, make sure that all requirements and conditions contained in the section on disconnecting the battery are met.

GENERAL INFORMATION, Precautions when working with electrical equipment.

WARNING: Before carrying out work on passive safety systems, it is necessary to carefully read the relevant technical documentation.

WARNING: Always remove both battery terminals before operating Passive Safety systems (SRS). First disconnect the "negative" terminal. Never mix up the wires when connecting to the battery pack.

CAUTION: The side impact sensor must be replaced after each side impact. Replace only the sensor for the side on which the impact occurred.

Dismantling

1. Follow all safety rules when working with passive safety systems.

GENERAL INFORMATION, Safety precautions when working with the airbag system (SRS).

2. Remove the door panel.

DOORS, REPAIR WORK, Door panel - front door.

3. Disconnect the connector from the airbag module.

4. Remove and discard the 3 airbag module mounting screws.

5. Remove the airbag module.

CAUTION: Store the air bag model with the deployable side facing up. If the air bag is stored with the deployable side facing down, if it accidentally deploys, it will be thrown upward with sufficient force to cause serious injury.

WARNING: Store airbags or pretensioners in a specially designated place. If there is no such place, then store these elements in the trunk or luggage compartment of the car, informing the technician about this.

The article was copied from a resource (www.LRman.ru)

Assembly

NOTE: If a component of the passive restraint system needs to be replaced, the bar code of the new component must be recorded.

1. Install the airbag module into the door, install new screws and tighten them to 9 N·m.

2. Connect the connector to the airbag module connector.

3. Install the front door panel.