Airbag Deployment
WARNING: Before working on passive safety systems, carefully read the relevant technical documentation.
1. Follow all safety rules when working with passive safety systems.
GENERAL INFORMATION, Safety Precautions When Working on the Airbag System (SRS).
2. Remove the glove box.
CAR INTERIOR PARTS, REPAIR WORKS, Glove box.
3. Disconnect the block from the airbag module connector.
4. Check the condition of the LRT-86-003 fixture and cables supplied with it.
5. Attach the cable of the LRT-86-003/05 tool to the airbag.
6. Attach the LRT-86-003 tool to the other end of the LRT-86-003/05 cable.
7. Attach tool LRT-86-003 to battery.
WARNING: Ensure that all persons are at least 15 m away from the air bag module.
8. To bring the airbag into action, press the power button on the fixture body.
9. Disconnect the tool from the battery.
WARNING: When deployed, parts of the airbag become hot and may cause burns. Wait 30 minutes after deployment before touching the airbag module.
10. Disconnect the accessory cable from the airbag.
ATTENTION: It is forbidden to reuse any parts of the passive safety systems.
NOTE: Do not transport parts of deployed restraint systems in the passenger compartment.
Comments on this article