Dismantling
1. Remove final drive with differential assembly.
MAIN GEAR AND DIFFERENTIAL, REPAIR WORK, Main gear with differential assembly.
2. Turn out 8 screws of fastening of a cover of a case of a back final drive.
3. Remove the cover.
4. Remove and discard gasket.
Assembly
1. Wipe the joint surfaces of the cover and the final drive housing.
2. Install the gasket and cover, tighten the screws and, bypassing them diagonally, gradually tighten the screws securing the cover with a torque of 45 Nm.
3. Install final drive with differential assembly.
MAIN GEAR AND DIFFERENTIAL, REPAIR WORK, Main gear with differential assembly.
Comments on this article