Draining and filling the working fluid (Range Rover 3)

Dismantling

1. Place the vehicle on a lift.

2. Install a container to collect the leaking working fluid.



3. Unscrew the drain plug and remove the sealing ring.

The material was taken from the specified website: www.lrman.ru

4. Allow the working fluid to drain.

Assembly

1. Clean the drain plug and drain hole, install a new sealing ring, screw in the plug and tighten it to a torque of 25 N·m.

2. Clean the area around the filler/inspection plug.



3. Unscrew the filler/inspection plug and remove the sealing ring.

4. Fill with working fluid until it flows out of the filler hole. Wait for the working fluid level to settle.

5. Clean the filler/inspection plug and install a new O-ring.

6. Replace the filler/inspection plug and tighten it to 25 Nm.