Rear output shaft seal (Range Rover 3)

Dismantling

1. Remove the rear propeller shaft.

DRIVE SHAFTS, REPAIR WORK, Cardan shaft - rear.

2. Remove the pin securing the output shaft flange nut.



3. Using the LRT-51-003 tool, hold the shaft flange from turning, loosen the nut and remove the flange from the shaft. Discard the nut and remove and discard the sealing ring.

4. Remove the oil seal from the transfer case housing.

Assembly

1. Clean the groove for the oil seal in the transfer case housing.

2. Using the LRT-41-020 tool, install the oil seal into the transfer case housing.

3. Clean the shaft flange and shaft mating surfaces.

4. Install a new sealing ring, fit the flange and tighten the mounting nut to 100 Nm.

5. Install the pin that locks the flange mounting nut.

6. Install the rear propeller shaft.

DRIVE SHAFTS, REPAIR WORK, Cardan shaft - rear.

7. Check and, if necessary, add working fluid to the transfer case to the required level.

TRANSFER CASE, ADJUSTMENTS, Draining and filling the working fluid.