Crankshaft pulley — removal and installation (Defender 2007+)

Removal

1. Disconnect the ground wire from the battery.

For more information, refer to the chapter: Disconnecting and connecting the battery (414-01 Battery, Battery Mounting and Cables, General Procedures).

2. Remove the cooling fan.

For more information, refer to the chapter: Cooling Fan (303-03 Engine Cooling - Diesel Engine ID4 2.4L, Removal and Installation).

3. Loosen the accessory drive belt. Turn the accessory drive belt tensioner clockwise.



4.

NOTE: Press the brake pedal, apply the parking brake, select first gear to lock the crankshaft.

Remove the crankshaft pulley. Unscrew and discard the 3 bolts.

Installation

1.

CAUTION: New crankshaft pulley bolts must be installed.

NOTE: Press the brake pedal, apply the parking brake, select first gear to lock the crankshaft.

The article is based on information from the website (www.LRman.ru)

NOTE: New crankshaft pulley bolts must be installed.

NOTE: Clean the contact surfaces of the elements.

Install the crankshaft pulley.

• Step 1: Tighten the bolts (tightening torque 45 Nm).
• Step 2: Tighten the bolts another 90 degrees.

2. Secure the accessory drive belt. Turn the accessory drive belt tensioner clockwise.

3. Install the cooling fan.

For more information, refer to the chapter: Cooling Fan (303-03 Engine Cooling - Diesel Engine ID4 2.4L, Removal and Installation).

4. Connect the ground wire to the battery.

For more information, refer to the chapter: Connecting the Battery (414-01 Battery, Battery Mounting and Cables, General Procedures).