Transfer case primary shaft seal (Defender 2007+)

Special tool(s)

Mounting device, seal 308-518

Removal

1. Disconnect the ground cable from the battery. For more information, refer to the chapter: Disconnecting and connecting the battery (414-01 Battery, Battery Mounting and Cables, General Procedures).

2.

WARNING: Never work on a vehicle supported only by a jack. Always support the vehicle with special stands.

Raise and support the vehicle.

3. Remove the transfer case.



For more information, refer to the chapter: Transfer Case (308-07A Transfer Case - ID4 2.4L Diesel Engine, Removal).

4. Remove and discard the transfer case input shaft seal.

Installation

1. Using the special tool, install a new transfer case input shaft seal.





2. Install the transfer case.

For more information, refer to the chapter: Transfer Case (308-07A Transfer Case - ID4 2.4L Diesel Engine, Installation).

(The original text can be found at: LRman.ru)

3. Connect the ground wire to the battery.

For more information, refer to the chapter: Connecting the Battery (414-01 Battery, Battery Mounting and Cables, General Procedures).