Contents: Dismantling ⇩ Assembly ⇩
Before disconnecting the battery, make sure that all requirements and conditions contained in the section on disconnecting the battery are met.
GENERAL INFORMATION, Precautions when working with electrical equipment.
Dismantling
1. Set the heater and air distribution system controls to the glass blowing mode.
If this is not done, the air duct flap supplying air to the feet will be damaged.
2. Disconnect the negative battery terminal.
3. Remove the glove box.
CAR INTERIOR PARTS, REPAIR WORK, Glove box.
4. Remember the installation position and disconnect the 8 connectors from the fuse box.
5. Remove the 4 Torx screws securing the fuse box and move it to the side.
6. Remove the screw securing the lower air duct to the fuse box bracket. Remove the air duct.
7. Remove the 4 Torx screws and spring retainer from the right heater duct elbow. Remove the duct elbow.
CAUTION: Hold the spring clip before releasing it.
The original source of the article is the website: LRMAN.ru
8. Disconnect the connector from the evaporator sensor, release the cable and remove the evaporator sensor.
Assembly
1. Carefully install the sensor and secure the sleeve.
2. Connect the connector block and secure the cable.
3. Position and secure the heater duct elbow.
4. Position and secure the lower heater duct.
5. Install the fuse box and secure it with screws.
6. Connect the connectors to the fuse box connectors.
7. Install the glove box.
CAR INTERIOR PARTS, REPAIR WORK, Glove box.
8. Connect the negative battery terminal.
Comments on this article