GENERAL INFORMATION, Precautions when working with electrical equipment.
Dismantling
1. Put the car on a lift.
2. Disconnect "negative" battery terminal.
3. Remove the lower engine protection.
EXTERIOR PARTS, REPAIR WORKS, Engine protection - front.
4. Loosen the two screws securing the compressor belt tensioner.
5. Turn out 2 screws of fastening of the tension device of a belt of a drive of the compressor and remove the tension device.
Assembly
1. Place the tensioner on the support, screw in the 2 screws and tighten them with a torque of 25 Nm.
2. Turn the tensioner to fully tension the compressor drive belt.
NOTE: Make sure the belt is correctly positioned in the pulley grooves.
3. Tighten the 2 belt tensioner screws to 25 Nm.
4. Reinstall the lower motor guard.
EXTERIOR PARTS, REPAIR WORKS, Engine protection - front.
5. Attach "negative" battery terminal.
Comments on this article