Engine Oil Pressure (EOP) Sensor — Removal and Installation (Defender 2007+)

Removal

1. Raise and support the vehicle.

For more information, refer to the chapter: Lifting the vehicle (100-02 Jacking and lifting a car on a lift, Description and operating principle).

2. Disconnect the electrical connector of the engine oil pressure (EOP) sensor.



3. Remove the EOP sensor.



The original article is located on [www.lrman.ru]

Installation

1. Install the EOP sensor. Tighten (tightening torque 15 Nm).

2. Connect the electrical connector of the engine oil pressure (EOP) sensor.