Engine Oil Pressure (EOP) Sensor (Freelander 2)

NOTE: The removal procedure description may contain installation steps.

Removal

1. Disconnect the battery ground cable. Refer to procedure: Specifications (414-00 Charging System - General Information, Specifications).

2. Raise the vehicle.

3. Remove the lower engine guard. Refer to procedure: Engine Guard (501-02 Front Body Panels, Removal and Installation).

(The source of the article is located on the website www.LRman.ru)





6. Tightening torque: 32 Nm

Fluid may leak. Replace the washer.

Installation

1. Installation is carried out in reverse order.

2. Check the engine oil level and top up if necessary.