Engine Oil Pressure (EOP) Sensor 2.7L (Discovery 3)

Removal

1. Disconnect the ground cable from the battery. For more information, refer to Specification.

2. Remove the engine cover. For more information, refer to Engine Cover - 2.7L Diesel (12.30.50)

3. Disconnect the electrical connector of the engine oil pressure (EOP) sensor.



4. Remove the EOP sensor.

Installation

1. To install, perform the removal procedure in reverse order. Tighten the EOR sensor (tightening torque 15 Nm).

2. Check the engine oil level and top up if necessary.