English Русский
Български
Беларускі
Український
Српски
Hrvatski
Română
Polski
Slovenský
Magyar

Mass Air Flow (MAF) Sensor 4.4L (Discovery 3)

Contents: Removal ⇩ Installation ⇩

Removal

1. Disconnect the ground cable from the battery. For more information, refer to Specification.

2. Remove the MAF sensor.

Disconnect the plug connector.
Remove two screws.

Remove two screws.

Installation

1. To install, reverse the removal procedure. Tighten the Torx head screws. (tightening torque 2 Nm).

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article review: Saveliy Ushakov

Previous articles

Specification 4.0L
Specification 4.4L
Specification 2.7L
Device and technical description 4.0L
Engine Control Module (ECM) 4.0L
Accelerator Pedal Position Sensor (APP) 4.0L
Oxygen Sensors 4.0L
Knock Sensors 4.0L

Current article

Mass Air Flow (MAF) Sensor 4.4L

Next articles

Mass Air Flow (MAF) Sensor 2.7L
Throttle Position Sensor (TP) 4.0L
Crankshaft Position Sensor (CPS) 4.0L
Crankshaft Position Sensor (CPS) 4.4L
Crankshaft Position Sensor (CPS) 2.7L
Camshaft Position Sensor (CMP) 4.0L
Camshaft Position Sensor (CMP) 4.4L
Camshaft Position Sensor (CMP) 2.7L

Similar articles from Land Rover repair manuals:
• Mass Air Flow (MAF) Sensor Freelander 2 (2006-2014)
• Mass Air Flow (MAF) and Temperature (IAT) Sensor Freelander 1 (1997-2006)
• Mass Air Flow (MAF) and Intake Air Temperature (IAT) Sensor Range Rover 3 (2001-2012)
• Mass Air Flow (MAF) Sensor — Removal and Installation Defender 2007+ (2007-2016)

Comments on this article

No comments yet

We use cookies to make pages load faster and provide a more user-friendly experience 🍪