Crankshaft Position Sensor (CPS) 4.4L (Discovery 3)

Removal

1. Disconnect the ground wire from the battery. For more information, please refer to the Specification.

2.

CAUTION: Never work on a vehicle supported only by a jack. Always support the vehicle with special stands.

Raise and support the vehicle.

3. Remove the engine protection. For more information, refer to Engine Protection (76.10.50)

4.

CAUTION: Before disconnecting or disassembling parts, make sure that the area around the contact surfaces and connections is clean. To avoid contamination of the system, close all open connections with plugs.

Remove the CKP sensor.

• Disconnect the electrical connector.
• Remove the Torx head screw.

Installation

1. Reinstall the components in reverse order. Tighten the Torx head screw. (tightening torque 8 Nm).