Oil temperature sensor 4.4L (Discovery 3)

Removal

1. Disconnect the ground cable from the battery. For more information, refer to Specification.

2. Remove the panel that covers access to the radiator. Unscrew 4 bolts.



3.

CAUTION: Before disconnecting or disassembling parts, make sure that the area around the contact surfaces and connections is clean. To avoid contamination of the system, close all open connections with plugs.

Remove the oil temperature sensor.

• Disconnect the plug connector.
• Place a container to collect any spilled oil.

Installation

1. To install, perform the removal procedure in reverse order.

• Tighten the oil temperature sensor (tightening torque 20 Nm).
• Tighten the bolts (tightening torque 10 Nm).

2. Check the engine oil level and top up if necessary.

(The original article can be found here: LRMAN.ru)