Oil temperature sensor (Freelander 2)

NOTE: The removal procedure description may contain installation steps.

Removal

1. Remove the cover and disconnect the ground cable from the battery. Refer to procedure: Specifications (414-00 Charging System - General Information, Specifications).

2. Remove the starter. Refer to procedure: Starter (303-06B Starting System - 2.2L Duratorq - Td4, Removal and Installation).

3. Tightening torque: 27 Nm

CAUTION: Install a new sealing washer.

The material was taken from the specified website lrman.ru

Installation

1. When installing, perform the removal procedure in reverse order.

2. Check the engine oil level and top up if necessary.