Contents: Dismantling ⇩ Assembly ⇩
Before disconnecting the battery, make sure that all requirements and conditions contained in the section on disconnecting the battery are met.
GENERAL INFORMATION, Precautions when working with electrical equipment.
WARNING: Always remove both battery terminals before operating the airbag system. First disconnect the negative terminal. Never mix up the wires when connecting to the battery pack.
Dismantling
1. Follow all safety rules when working with the airbag system.
GENERAL INFORMATION, Safety precautions when working with the airbag system (SRS).
2. Remove the airbag module from the steering wheel.
RESTRAINT SYSTEMS FOR DRIVER AND PASSENGERS, REPAIR WORK, Airbag module - steering wheel.
3. Remove the two Allen screws and separate the control unit from the airbag.
4. Disconnect the control unit connector blocks and remove the control unit.
Assembly
1. Install the control unit and connect the connector blocks.
2. Install the control unit onto the airbag and tighten the bolts to 2.5 Nm.
3. Install the driver's airbag.
RESTRAINT SYSTEMS FOR DRIVER AND PASSENGERS, REPAIR WORK, Airbag module - steering wheel.
4. Connect the battery terminals, negative terminal first.
[The article is based on information from the website www.LRman.ru]
Comments on this article