Exhaust gas recirculation control unit (Discovery 1)

1. Disconnect the two glove box posts from the front panel and pivot the glove box downwards.

2. Unscrew the two plastic nuts securing the control unit.

3. Remove the control unit from the clips.

4. Disconnect the wiring connector.

5. Installation in reverse order.

[The article was copied from a resource: www.LRman.ru]

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article review: Konstantin Nazarov

Tdi fuel system — design description
Description of the electronic fuel injection pump control system
Operation of the electronic control system
Adjustments — accelerator cable (fuel injection pump lever)
Fuel injection pump lever position sensor (for the exhaust gas recirculation system)
Idle speed
Checking the boost pressure
Repair — Fuel Level Sensor

Current article

Exhaust gas recirculation control unit

Fuel injection pump lever position sensor (EGR system)
Injectors — removal
Fuel injection pump and injection advance angle
Engine control unit
Air flow sensor
Boost pressure sensor
Injector needle lift sensor
Speed sensor

Comments on this article

No comments yet

Discovery 3

Discovery 1