Fuel injection pump lever position sensor (EGR system) (Discovery 1)

1. Unscrew the two screws securing the sensor to the fuel injection pump board.

2. Disconnect the sensor connector.

3. Remove the sensor.

4. Installation in reverse order, adjust the position of the sensor, see above.

The material was taken from the specified website www.lrman.ru

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article review: Konstantin Nazarov

Tdi fuel system — design description
Description of the electronic fuel injection pump control system
Operation of the electronic control system
Adjustments — accelerator cable (fuel injection pump lever)
Fuel injection pump lever position sensor (for the exhaust gas recirculation system)
Idle speed
Checking the boost pressure
Repair — Fuel Level Sensor

Current article

Fuel injection pump lever position sensor (EGR system)

Injectors — removal
Fuel injection pump and injection advance angle
Engine control unit
Air flow sensor
Boost pressure sensor
Injector needle lift sensor
Speed sensor
Vehicle speed sensor

Comments on this article

No comments yet

Discovery 3

Discovery 1