Draining and filling the working fluid (Range Rover 3)

Drain

1. Place the vehicle on a lift.

CAUTION: Use caution when draining hydraulic fluid, which may be very hot.

2. Apply the parking brake and place chocks under the front and rear wheels.

3. Place a container to collect the working fluid under the automatic transmission.

NOTE: Drain the transmission fluid when the transmission is at operating temperature.

4. Wipe the area around the drain plug.



5. Remove and discard the drain plug.

6. Allow the working fluid to drain.

7. Clean the drain hole, install a new drain plug and tighten it to 20 N·m.

Filling

1. Clean the area around the filler/inspection plug.



2. Remove and discard the filler/inspection plug.

3. Fill with 3.5 to 4 liters of the recommended working fluid through the filler/inspection hole.



4. Install a new filler/inspection plug and tighten it to 20 Nm.

5. Check the working fluid level and top up to the lower edge of the filler hole.

The original text can be found at [www.LRman.ru]