Gear shift solenoid (Range Rover 3)

Dismantling

1. Remove the automatic transmission pan.

AUTOMATIC TRANSMISSION - GM 5L40-E, REPAIR WORK, Gasket - oil pan of automatic transmission.

2. Disconnect the connector block from the solenoid.

3. Release and remove the solenoid spring retaining ring.

4. Remove the solenoid from the valve body and discard the O-rings.

Assembly

1. Wipe the mating surfaces of the solenoid and valve.

2. Install new O-rings on the solenoid and lubricate them with automatic transmission fluid.

3. Install the solenoid on the valve body and secure it with the retaining ring.

4. Connect the connector to the solenoid connector.

5. Reinstall the automatic transmission oil pan.

AUTOMATIC TRANSMISSION - GM 5L40-E, REPAIR WORK, Gasket - oil pan of automatic transmission.

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article review: Platon Fedorov

Draining and filling the working fluid
Checking and adjusting the gear selector cable
Gear selector lever
Gear selector lever handle
Assembling the gear selector lever and cable
Starter interlock switch
Gear selector shaft seal
Torque Converter Lock-Up Clutch Electromagnet

Current article

Gear shift solenoid

Electronic control unit
Solenoid valve wiring harness
Intermediate shaft speed sensor current collector
Current collector of the primary shaft speed sensor
Torque converter seal
Automatic transmission and torque converter
Removal and installation of automatic transmission assembly with transfer case
Rear extension housing seal

Comments on this article

No comments yet

Range Rover 3