English Русский
Български
Беларускі
Український
Српски
Hrvatski
Română
Polski
Slovenský
Magyar

Front suspension compression buffer (Defender 2007+)

Contents: Removal ⇩ Installation ⇩

Removal

1. Remove the dynamic deflection limiter.

1. Remove the dynamic deflection limiter.

Installation

1. Place the bolts into the slots in the chassis brackets.

2. Install the suspension dynamic deflection limiter and secure it with washers and nuts.

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article review: Saveliy Ushakov

Previous articles

Suspension specification
Adjusting the front wheel alignment
Rear air shock absorber
Rear shock absorber
Upper arm rear suspension
Rear anti-roll bar rear suspension
Description and operating principle of the rear suspension
Lower arm rear suspension

Current article

Front suspension compression buffer

Next articles

Wheel bearing and front wheel hub
Front shock absorber
Front stabilizer bar
Longitudinal balancer (longitudinal lever)
Front suspension spring
Front stabilizer bar
Front suspension panhard rod
Front suspension wheel studs

Similar articles from Land Rover repair manuals:
• Description and operating principle of the front suspension Freelander 2 (2006-2014)
• Front Suspension Specification Freelander 1 (1997-2006)
• Front Suspension Specification Discovery 3 (2004-2009)
• Front suspension — device Discovery 1 (1989-1998)
• Front and rear suspension Range Rover 3 (2001-2012)

Comments on this article

No comments yet

We use cookies to make pages load faster and provide a more user-friendly experience 🍪