Rear brake disc (Range Rover 3)

Dismantling

1. Raise the rear of the vehicle.

CAUTION: Do not work under a vehicle supported solely by a jack or lift. Always support the vehicle with safety stands.

2. Remove the wheel.



3. Remove the two screws securing the caliper to the wheel bearing support. Remove the caliper from the support and secure it to the side.

CAUTION: Do not allow the caliper to hang by the brake hose.

4. Remove the Allen screw securing the brake disc to the wheel hub flange.

5. Remove the brake disc.

Assembly

1. Make sure the mating surfaces of the brake disc and hub flange are clean.

2. Install the brake disc on the hub flange, install the mounting screw and tighten it to a torque of 16 Nm.



3. Install the caliper onto the wheel bearing support and tighten the screws to a torque of 65 N·m.

4. Replace the wheel and tighten the nuts to a torque of 140 Nm.

5. Adjust the parking brake.

BRAKE SYSTEM, ADJUSTMENTS, Parking brake adjustment.

6. Remove the supports and lower the vehicle.