Removal
1. Remove the wheel hub.
2. Unscrew the brake disc mounting bolts.
3. Remove the disc.
Installation
4. Install the disc on the hub.
5. Tighten the mounting bolts to a torque of 75 Nm.
6. Check the disc runout at the periphery. If the runout exceeds 0.15 mm, move the disc to another position.
7. Install the hub.
Disc repair
8. Restoring the disk surface by mechanical processing is permitted up to a thickness of 12 mm. The metal removal thickness must be equal on both sides.
Comments on this article