Temperature sensor in the junction box (Range Rover 3)

Before disconnecting the battery, make sure that all requirements and conditions contained in the section on disconnecting the battery are met.

GENERAL INFORMATION, Precautions when working with electrical equipment.

Dismantling

1. Disconnect the negative battery terminal.



[The text of the article was taken from the website LRMAN.ru]

2. Remove the 10 screws securing the cover of the mounting box and remove the cover.



3. Disconnect the connector from the temperature sensor in the junction box.

4. Remove the temperature sensor in the junction box.

Assembly

1. Install the temperature sensor into the mounting box.

2. Connect the connector to the temperature sensor of the junction box.



3. Install the cover of the mounting box, screw in the screws and tighten them to a torque of 2 N·m.

4. Connect the negative battery terminal.

5. If a new sensor has been installed, reconfigure the control system using the TestBook/T4 device.