General information (Freelander 2)

Operating principle

For a detailed description of the transmission systems, refer to the relevant section "Description and Operation" in the workshop manual. For additional information, refer to:

• Cardan shaft (205-01 Cardan shaft, Description and principle of operation),
• Cardan joints (205-01 Cardan shaft, Description and operating principle),
• Rear Drive Axle and Differential (205-02 Rear Drive Axle/Differential, Description and Operating Principle),
• Front Drive Axle and Differential (205-03 Front Drive Axle/Differential, Description and Operating Principle),
• Front Drive Axle Shafts (205-04 Front Drive Axle Shafts, Description and Operating Principle),
• Rear drive axle half-shafts (205-05 Rear drive axle half-shafts, Description and operating principle).

Inspection and verification

CAUTION: Diagnostics by substituting a component from another vehicle is NOT permitted. Substituting control modules does not guarantee confirmation of the fault and, in addition, may cause additional faults in the vehicle being tested and/or in the vehicle from which the modules are removed.

NOTE: Certain transmission problems also apply to the engine, transmission, wheel bearings, tires, and other components of the vehicle. For this reason, make sure the transmission is the cause of the problem before adjusting, repairing, or installing any new components.

1. Visually inspect the system for integrity and obvious signs of damage.

2. If an obvious cause for the problem you identified or the customer described is found, correct it (if possible) before moving on to further action.

3. If the cause is not visually obvious, check the symptom and refer to the Symptom Chart or check for DTCs and refer to the Diagnostic Trouble Code (DTC) Index.