Rear Door Module (RDM) (Freelander 2)

Removal

1. Disconnect the battery ground cable. Refer to procedure: Specifications (414-00 Charging System - General Information, Specifications).

2. Remove the rear door trim panel. Refer to procedure: Rear Door Trim Panel (501-05 Interior Trim, Removal and Installation).

2. Remove the rear door trim panel. Refer to procedure: Rear Door Trim Panel (501-05 Interior Trim,…

Installation

1. When installing, perform the removal procedure in reverse order.

2. Connect the ground cable to the battery. Refer to Procedure: Specifications (414-00 Charging System - General Information, Specifications).

3. If a new component has been fitted, configure using Land Rover approved diagnostic equipment.

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article review: Roman Mitrofanov

Layout of elements — LIN bus
Element location — medium speed CAN bus
Element location — High speed CAN bus
Element location — MOST
Overview of control modules
Inspection and verification
DTC Trouble Code Index
Front Door Module (FDM)

Current article

Rear Door Module (RDM)

Driver Seat Module (DSM)

Comments on this article

No comments yet

Freelander 2

Freelander 1