Contents: Dismantling ⇩ Assembly ⇩
Dismantling
1. Remove the control panel end panel.
CAR INTERIOR PARTS, REPAIR WORK, End panel - control panel.
2. Remove the deflector that supplies air at face level.
HEATING AND VENTILATION, REPAIR WORKS, Control panel ventilation grille - face level.
3. Remove the upper trim of the "A" pillar of the body.
CAR INTERIOR PARTS, REPAIR WORK, Trim - pillar "A" - upper.
4. Remove the 3 Torx screws securing the top cover to the control panel.
5. Disconnect the upper trim from the control panel and remove the switch connector block.
6. Disconnect the passenger footwell light connector.
7. Remove the top control panel cover.
NOTE: If disassembly was performed only to provide access to other system components, no further disassembly operations should be performed.
8. Remove the switch from the cover.
9. Squeeze the clips and remove the floor light from the top trim.
Assembly
1. Install the lamp into the upper control panel trim.
2. Install the switch into the top cover of the control panel.
3. Connect the connector blocks.
4. Install the top cover onto the control panel and secure it with screws.
5. Install a deflector that supplies air at the level of the passengers' faces.
HEATING AND VENTILATION, REPAIR WORKS, Control panel ventilation grille - face level.
6. Install the control panel end panel.
CAR INTERIOR PARTS, REPAIR WORK, End panel - control panel.
7. Install the "A" pillar trim.
CAR INTERIOR PARTS, REPAIR WORK, Trim - pillar "A" - upper.
Comments on this article