Wheel arch inner panel reinforcement (Range Rover 3)

Contents: Dismantling ⇩ Repair works ⇩ Assembly ⇩

The procedure for removing the inner wheel arch panel reinforcement is similar to removing the side member assembly.

Dismantling

1. Remove the front side member assembly.

REPAIR WORK, Front side member assembly.

Repair works

1. Remove damaged panels, prepare joint edges and install new panels in accordance with the Body Panel Repair Rules. Punch or drill holes in the panel to be installed for the plug weld, as shown in the figure.

Assembly

1. Install the front side member assembly into place.

REPAIR WORK, Front side member assembly.

The original was published on the portal: LRMAN.ru

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article review: Platon Fedorov

Replaceable body parts
General safety rules for welding
Panel replacement procedure
Front panel assembly
Hood Lock Panel
Headlight mounting panel
Radiator protection
Front spar end panel

Current article

Wheel arch inner panel reinforcement

Inner wheel arch panel
Front A-pillar body side panel
A-pillar reinforcement panel
Side panel of the body of the threshold section
Side body panel threshold and B/C sections of the central pillar
Central pillar reinforcement panel B/C
Threshold reinforcement panel
Rear section body side panel

Comments on this article

No comments yet

Range Rover 3