Contents: Dismantling ⇩ Assembly ⇩
Before disconnecting the battery, make sure that all requirements and conditions contained in the section on disconnecting the battery are met.
GENERAL INFORMATION, Precautions when working with electrical equipment.
Dismantling
1. Disconnect the negative battery terminal.
2. Remove the air intake box.
HEATING AND VENTILATION, REPAIR WORKS, Air intake box.
3. Disconnect the connector from the boost pressure sensor.
4. Loosen the boost pressure sensor mounting bolt and remove the sensor. Discard the gasket.
Assembly
1. Wipe the boost pressure sensor and its installation location.
2. Using a new gasket, install the pressure sensor and tighten the mounting bolt. Tightening torque 8 Nm.
3. Connect the connector to the boost pressure sensor.
4. Install the air intake box in place.
HEATING AND VENTILATION, REPAIR WORKS, Air intake box.
The text of the article was taken from the website www.LRman.ru
5. Connect the negative battery terminal.
6. If a new sensor has been installed, reconfigure the control system using the TestBook/T4 device.
Comments on this article