Contents: Dismantling ⇩ Assembly ⇩
Before disconnecting the battery, make sure that all requirements and conditions contained in the section on disconnecting the battery are met.
GENERAL INFORMATION, Precautions when working with electrical equipment.
Dismantling
1. Disconnect the negative battery terminal.
2. Remove the intake manifold.
EXHAUST MANIFOLD & DUMP SYSTEM: V-8 Engine, REPAIR, Intake Manifold Gasket(s).
3. Loosen the two bolts securing the knock sensor (KS) to the cylinder block and remove the sensor.
Assembly
1. Wipe the knock sensor (KS) and mating surfaces on the cylinder block.
2. Install the knock sensor (KS) on the cylinder block, screw in the sensor mounting bolts and tighten them to a torque of 20 Nm.
3. Install the intake manifold.
EXHAUST MANIFOLD & DUMP SYSTEM: V-8 Engine, REPAIR, Intake Manifold Gasket(s).
4. Connect the negative battery terminal.
5. If a new sensor has been installed, reconfigure the control system using the TestBook/T4 device.
The article was taken from this resource (www.LRman.ru)
Comments on this article