Removing
1. Remove the seat sled from the driver's side. For more information, refer to the chapter: Front seat rail (501-10 Seat, Removal and installation).
2. Remove the front seat cushion base. For more information, see chapter: Front seat cushion (501-10 Seat, Removal and installation).
3.
4.
5. Tightening torque: 25Nm
6.
- Secure the seat base with the four included clamps as shown in the illustration.
- Use the seat height adjuster to lower the seat base as far as it will go.
Clamps must be installed; failure to do so may result in personal injury. Failure to follow this recommendation may result in a malfunction of the vehicle.
7. Release the height adjuster lever. Turn out with a bolt head Torx.
8. Drill out four rivets.
Installation
1. Install the elements in the reverse order of disassembly.
Comments on this article