Dismantling
1. Follow all safety rules when working with the airbag system.
GENERAL INFORMATION, Airbag and seat belt pretensioner regulations.
2. Remove the seat base trim.
SEATS, REPAIR WORKS, Linings of the basis of front seats.
3. Release the seat belt pretensioner electrical connector from the seat frame and disconnect it.
4. Remove the cap from the rear slide mounting bolt.
5. Loosen the 4 Torx screws securing the sled.
6. Remove the front seat.
Installation
1. Install the front seat and secure with Torx screws. Tighten the screws with a torque of 45 Nm.
2. Install the cap on the rear bolt.
3. Connect the electrical connector to the pretensioner and secure it to the seat base.
4. Install the seat base trim.
SEATS, REPAIR WORKS, Linings of the basis of front seats.
Comments on this article