Combination light — rear (Freelander 1)

Dismantling

1. Remove the 3 Torx screws securing the light to the body.

2. Release the flashlight, disconnect the 2 bulb holders and remove the flashlight.

3. Remove the rubber seal of the lamp.

Installation

1. Install the rubber seal and bulb holders into the light.

[The source of the article is located on the website: www.lrman.ru]

2. Install the light, install and tighten the Torx screws.

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article review: Konstantin Nazarov

Headlamps — pair — light adjustment — up to 04MY
Headlamps — pair — light adjustment — from 04MY
Headlight assembly — models up to 04MY
Headlight assembly — models from 04MY
Turn signal repeater lamp
Rear combination light
Lantern — license plate lighting
Combination light — fog light/side lights — models from 04MY

Current article

Combination light — rear

Lamp — Center High Mounted Stop Light (CHMSL)
Lantern — glove box
Lantern — cargo compartment
Switch — headlight adjustment
Switch — Glove Box
Switch — hazard warning light
Switch — combined, direction indicators / headlights / horn
Switch — rear fog lights

Comments on this article

No comments yet

Freelander 2

Freelander 1