B-pillar interior trim panel (Freelander 2)

NOTE: The inner "B" pillar panel is serviced as a separate weld-on panel.

Removal

1. When replacing the reinforcing element of the "B" pillar, the following elements are removed:

Front door
Back door
Ceiling lining
External panel of the "B" pillar
Reinforcing element of the rack "B"

2. For additional information on this repair procedure, refer to the following sources: For additional information, refer to: Body and Frame (501-26 Body Repairs - Vehicle Specific Information and Tolerance Checks, Description and Operation) / Standard Service Station Techniques (100-00 General Information, Description and Operation).

3. Remove the B-pillar reinforcement. For more information, refer to: B-Pillar Reinforcement (501-29 Side Panel Sheet Metal Repairs, Removal and Installation).

4. Mill out the contact welding areas.

(See the source on the website: www.lrman.ru)

5. Separate the connections and remove the panel.

Installation

1. Prepare the mating surfaces of the old and new panels.

2. Drill holes in the new panel in preparation for MIG welding.

3. Place the new panel in the required location and secure it. Check the alignment of the position; if correct, proceed to the next step. If not, correct and recheck before continuing.

4. Perform electric rivet welding using MIG technology.