Anti-lock braking system module (Freelander 2)

Maintain absolute cleanliness when handling these elements. If brake fluid gets on the paintwork, immediately wash the affected area with cold water.

Removal

All cars

1. Raise and support the vehicle.

WARNING: Ensure that the vehicle is supported securely.

2. Disconnect the battery ground cable. Refer to Procedure: Specifications (414-00 Charging System - General Information, Specifications).

3. Remove the battery tray. Refer to the procedure: Battery Installation Tray (414-01 Battery, Battery Fastener and Cables, Removal and Installation).

Right hand drive vehicles

4. Remove the mixing chamber panel.

Left-hand drive vehicles

5. Remove the windshield wiper motor and linkage. Refer to procedure: Windshield Wiper Motor (501-16 Windshield Wipers and Washers, Removal and Installation).

6.

CAUTION: Plug all openings.

All cars







Left-hand drive vehicles



7.

Prepare to collect spilled liquid. Plug all openings.

Right hand drive vehicles

8.

Prepare to collect spilled liquid. Plug all openings.

All cars

9.

Prepare to collect spilled liquid. Plug all openings.

Installation

All cars

1. Install the ABS module. Tightening torque: 10 Nm

2. Install the brake pipes. Tightening torque: 15 Nm



3. Install the battery tray support. Tightening torque: M6 - 10 Nm, M8 - 25 Nm

Left-hand drive vehicles

4. Connect the brake booster vacuum line.

All cars

5. Install the ECM.

6. Secure the vacuum line and connection block.

Left-hand drive vehicles

7. Install the windshield wiper motor and linkage. Refer to procedure: Windshield Wiper Motor (501-16 Windshield Wipers and Washers, Removal and Installation).

Right hand drive vehicles

8. Install the collection chamber panel.

All cars

9. Install the battery tray. Refer to the procedure: Battery tray (414-01 Battery, Battery Fastener and Cables, Removal and Installation).

[The original article can be found here LRman.ru]

10. Connect the ground cable to the battery. Refer to Procedure: Specifications (414-00 Charging System - General Information, Specifications).

11. Bleed the brake system. Refer to procedure: Bleeding the Brake System (206-00 Brake System - General Information, General Procedures).

12. If a new component has been fitted, configure using Land Rover approved diagnostic equipment.