ABS Front Wheel Speed Sensor (Range Rover 3)

Dismantling

1. Raise the front of the vehicle on one side.

CAUTION: Do not work under a vehicle supported solely by a jack or lift. Always support the vehicle with safety stands.

2. Remove the front wheel.



3. Open the cover covering the sensor cable connector, release the connector and disconnect the wheel speed sensor connector.



4. Release the sensor cable from the retainer on the vehicle body, the clamp and the retainer on the brake hose.



5. Release the cable from the retainer on the shock absorber, remove the Allen screw and remove the wheel speed sensor from the wheel bearing support.

Assembly

1. Clean the surface of the wheel speed sensor, apply anti-seize lubricant to the sensor, and install it on the wheel bearing support.

FILLING CAPACITIES, USED OPERATING LIQUIDS, OILS AND SEALANTS, Lubrication system.

2. Install the wheel speed sensor mounting screw and tighten the screw to a torque of 8 N·m.

3. Fix the sensor cable to the shock absorber, to the brake hose bracket, to the retainer and clamp on the car body, then connect the cable block to the connector and fix the connector. Close the connector cover.

4. Replace the wheel and tighten the nuts to a torque of 140 Nm.

5. Remove the supports and lower the vehicle.

6. To ensure that the ABS is working properly, it is necessary to carry out diagnostics using the Testbook/T4 diagnostic device.